Featured Ranges > Pacer Yachts > Pacer 376 CR

Pacer 376 CR

This beautiful yacht is the 'cruiser/racer' of the 376 range. She has a Vinylester composite hull and deck, with a high quality gelcoat finish. Main differences which set her apart from her sister models are the cockpit which is enclosed at the stern, and the fact that all her rigging controls are routed back to the cockpit differently. She is supplied with an alloy Selden rig, North Sails genoa and mainsail, and a 20hp Volvo inboard engine with saildrive and fixed prop.


Type:Pacer 376 CR
Designer:Simonis Vooigd Design
Length Overall:11.46m
Length of Waterline:10.48m
Construction material:Vinylester Composite


All lines lead back to the cockpit on either port or starboard of the coachroof. Halyards and sail trims lead to a series of power clutches in turn leading to a respective Winch on the coachroof.

Winches: Lewmar
· 2 x Coachroof Halyard and spinnaker Winches – 2 x 44AST
· 2 x Primary Winches 46AST
· 2 x Mainsheet Winches 46AST

2 Winch handle pockets and 2 winch handles are supplied.

The Lewmar ‘German’ mainsheet track system is positioned fwd of the steering wheel pedestal, with car position controls leading to port and starboard for easy of trimming.

The Jib car is set using a stopper system.

The exterior manual bilge pump point is positioned on port, aft of the steering wheel affording the helmsman easy access.


All blocks and tracks are Lewmar with bearings, and tracks have control lines leading back to the cockpit.


Aft Cabins: 1 each opening to cockpit
Plus 1 in enclosed cabin on Starboard opening through coachroof side.
Saloon: 2 x portlights opening through existing windows of the coachroof.
Saloon: 1 opening to deck
Heads: 1 opening to deck
Fwd Cabin: 1 opening to deck.


The rig is keel stepped by Selden, in aluminium, with a natural anodized finish, offering;
· Masthead taper
· Aluminium Boom
· Two pairs of Spreaders
· Track on mast for spinnaker pole
· Fixed boomvang
· Windex (manual)
· Roller Furling Headsail as STD


Dyform stainless steel wire shrouds and stays with roll-formed terminals and bottle-screws.

The backstay is adjustable via a Lewmar cascade and purchase system.


The mainsheet system offers 2 conventional reefs, both controlled from the cockpit.

The mainsail and jib halyards are dyneema. There is 1 masthead spinnaker halyard, and 1 fractional spinnaker halyard.

The mainsail outhaul, and Cunningham, is adjustable from the cockpit.


North Sails Mainsail crosscut Dacron 430 with two reefing points, two full battens and 2 short battens – with a non backstay-overlapping roach. Furling North Sails Jib, Premium Nordac.


The Pacer 376 CR is fitted with a cold water pressurized fresh water system, upgradable to hot water. Faucets in Galley and Heads.
Black Water Tank is fitted under fwd V berth bunks with extraction via the deck.

2 x Manual Bilge Pumps
1 x Electric Bilge Pump


Batteries: 1 x 12v/55ah Starter
1 x 12v/100ah House

Mastervolt or similar Main Battery Switches.

Circuit Breakers for all electrical components.

Philipi or Similar Control Panel for Electronics.

25ah Battery Charger (Optional)

Shore-Power and Plug & Cable. 220v Plug point at Nav Station. (Optional)


VHF Preparation (wiring and antenna)


Interior general:
Halogen downlights in saloon & Galley, aft and fwd cabin, as well as heads.

Nav Station:
Working light at Nav Station.

Reading Lights:
Adjustable reading lights in Aft and fwd cabins.

Outside Lights:
Pulpit Fixed Port and Starboard Navigation Lights

Pushpit fixed White stern light.

Combined three-colour masthead light and anchor light.


20hp Volvo Penta compact diesel engine D1-20, 3 cylinder.
Saildrive with 2 blade fixed propeller.
Alternator – 14v / 115a


Fuel: 110ltr
Water: 110ltr


4 x Mooring Cleats
Safety Boarding/swim Ladder
Filler Nozzle for water tank on cockpit floor.
Filler Nozzle for fuel tank on cockpit floor.

Specifications are subject to change at the discretion of Pacer Yachts and will be confirmed at time of order.


Mainsail 48.6m
Code 1 Jib 36m2
Code 2 Jib 36m2
Code 0 95m2
Spinnaker Masthead 129m2
P 15.4m
E 5.25m
I 15.32m
J 4.3m

Standard Specifications:

The Pacer 376 CR is built in accordance with CE-Certification and meets the requirement for Cat A (ocean) for recreational craft.


The Hull is built using vacuum bagged hand lay-up. The Vinylester construction incorporates balsa as sandwich material. Internally the laminate is sealed using topcoat.


The Deck and Hull are bonded together providing a neat joint. The laminated construction consists of polyester epoxy resin, multidirectional fabrics with end-grain balsa as a core material.

In addition to Aluminium reinforcements laminated into the deck for the standard deck layout, Hard spots for post O.E.M fitment of deckgear are integrated in the deck.

The Pacer 376 CR offers a factory developed non-skid surface which is white in colour.


Stainless steel Pushpits and Pulpit are fitted, together with 610mm stainless steel stanchions with two safety wires, the bottom-most raised slightly to aid hiking.


The deck has an integrated toe rail extending from bow to mast.


With ease of use, maintenance and cleaning in mind, the Pacer 376 CR employs the use of GRP moulded interior modules, interior hull liners where applicable offering superior finishes, and a full-length ceiling liner with integrated down-lighting.

Structural integrity is assured via marine-plywood bulkheads, each bonded to hull and deck.

The cabinetry is of the highest quality light Cherrywood with a matt protector finish. There is a good balance between functionality and aesthetics.

The floorboards are Marine Plywood finished with a hardwearing synthetic Walnut composite material.

The washboards consist of a two-piece translucent removable system, which when in place locks to the translucent sliding cover. A stainless steel sill protector leads you down the ladder/stairs which are integrated into the engine cover.

Engine Cover:
GRP moulded unit with sound damping, fixes to rear bulkhead, light and easily removable for excellent access to the engine.

Aft Cabins:
Both cabins offer double berths with lockers positioned against the back bulkheads and ceiling. Optional shelving available fitted to the midships cabin divider. Lighting in the form of bulkhead adjustable spots for reading. A Hull liner gives a smooth easy-wipe finish, and ceiling liner screens all through-deck fittings. High density Mattresses are covered in removable wear resistant fabric.
Natural light and fresh air is accessible through a port light which opens to the cockpit. Also available is an optional ‘cabin’ enclosure which extends from the line of the Navigation table seat across to the companionway steps and back to the main aft bulkheads. This option affords privacy to the aft stbd berth, and includes an opening portlight which gives natural light and fresh air to the cabin.

Positioned on Port at the foot of the companionway, the Galley is L shaped to offer best sea-going attributes. Fitted with a single deep stainless steel sink, pressurized cold water with faucet as standard and hot and cold as an upgrade. The 41ltr compressor cold box has a hinged lid with recessed fold-down handle. The worktop is finished in hardwearing Corian and has a solid timber fiddle on all sides. A 2 plate, semi-gimbaled, stove is fitted as standard. Lockers for pots, pans and victuals are located above the worktop, with lockers under, of which one includes an integrated waste bag holder.

Navigation Station:
Adjacent to the galley and fwd of a wet-locker and other lockers, which are ideally positioned at the foot of the companionway, is the Chart Table and Nav Station. The desk has an opening lid, and fiddles. The Panel for instrumentation and Electrical Switchboard is located at head-height when seated and is easy to access. Both a 12v socket and 220v Socket is located at the Nav Station.

A spacious saloon with 2 linear couches adjacent to each other and a contoured timber table on aluminium pedestals with the starboard leaf folding to give excellent through-access to the fwd cabin / heads, compliment the saloon. Generous timber shelving runs either side of the saloon to the fwd bulkhead, behind the couches. The couch cushions are designed to lift individually, thereby enabling quick and easy access to the storage under.
A stainless steel grab-handle is fitted to the underside of the coachroof (midships) to aid access to the saloon whilst at sea.
A ceiling liner with recessed halogen down-lighting affords a high quality finish to the saloon.

Positioned fwd of the main saloon bulkhead and mast and accessed via the single forward berth bulkhead door, the head offers standing headroom, a wash-basin with cold water faucet, manual pump toilet, integrated shower head with electric shower sump pump and storage lockers. A hatch provides fresh air and natural light. A Halogen light is also fitted. An option is a second Heads door which will give access through the saloon fwd bulkhead (port side), thereby affording the forward cabin extra privacy. (must be confirmed at time of order)

Forward Cabin:
High quality double V berth mattresses with removable covers. Smooth, easy-wipe hull liner as well as a ceiling liner with recessed halogen downlights. Single cushioned seat alongside a locker adjacent to the heads door. Good stowage is accessible under the V berth via a locker door. A generous shelf in matching timber is fitted to both port and starboard sides of the cabin for extra stowage. Access to the anchor locker (optional) is via a fwd bulkhead waterproof hatch.


The keel consists of a combination of cast iron forming a medium draft foil, with a cast antimony hardened lead bulb. The keel is fastened to the hull recess by a series of stainless steel bolts with loads being distributed via the floor beams evenly through the laminate construction of the hull.


The elliptical balance rudder has a shaft of sea-water resistant stainless steel with an integrated high-strength framework within the GRP foil shape. Self-aligning rudder needle bearings provide the lowest possible friction and ultimate control for the helmsman.

The steering system is ‘Jefa’ type, consisting of a quadrant connected to the shaft, with the gearing offering responsive steering by way of a single wheel, itself fitted to a purpose-made centre pedestal with integrated binnacle for compass and instrumentation.


The Pacer 376 CR offers a large modern self-draining cockpit, very well laid-out for ease of sailing, whether short-handed or with a full crew complement.

The Gas locker is easily accessible on the port side of the cockpit, and the engine throttle control on the starboard side of the cockpit within reach of the helmsman.

A transom fitted locker (designed for life raft or general use) is provided, and access to the lazarette (steering gear and systems) is via a waterproof frosted-glass deck hatch.

The coamings are contoured for comfort and the deck surfaces have the factory developed non-skid.

Two seats are located either side of the helmsman’s seat to close off the transom and offer excellent seating choices. The helmsman’s seat is hinged to give good access to the lazarette hatch, and a walkthrough access to the transom

ID: 4064

Pacer 376 CR Dealers:

International > North America > USA > No dealers listed.

See Pacer Yachts at http://www.paceryachts.co.za

Place an Advert | My Account | Register