£75,000 | | |
Status: | Available |
Tax Status: | Tax Paid |
Location: |
Fareham Hampshire UK [View Map] |
2013 Bruce Roberts Voyager 388
Steel 13 metre cutter.
Located on pontoon mooring, Fareham.
In excellent condition, launched in 2022 with all new fixtures and fittings rigging and engine for planned passage to central America, change in circumstance's now requires Crow to be sold.
2022 Pre-launch survey.
Vessel type: | Bermudan Cutter |
Designer: | Bruce Roberts |
Make: | Bruce Roberts |
Model: | Voyager 388 |
Constructed: | 2013 |
Registry: | SSR |
No. of engines: | 1 |
Engine model: | Beta |
Engine power: | 60 |
Engine hours: | 45 |
Fuel type: | Diesel |
Drive type: | Shaft drive |
Length over all: | 13.1m |
Beam: | 4' 27" |
Maximum draft: | 1' 80" |
Hull material: | Steel |
Hull type: | Displacement |
Hull colour: | Blue |
Keel type: | Fin Keel |
Displacement: | 14 metric tons |
Fuel capacity: | 290 Litres |
Water capacity: | 290 Litres |
Holding tank capacity: | 60 Litres |
Three cabin layout, entry via companionway to central raised deck salon cabin.
Deck salon comprising - Navigation station to portside, wet locker, storage, to starboard pilot berth, large top access fridge.
Electric controls and monitoring.
Engine access from central cabin sole, Portside water tanks, starboard side diesel.
Portside companion way leading to aft cabin,
Aft cabin, large storage locker, access to steering, diesel heater.
Storage, single bunk to starboard, single transverse bunk.
Forward cabin via companion way from central salon leading to port side galley with double sink, hot and cold water.
3 burner Oven and grill, storage.
Starboard side heads with hot and cold water, electric macerator toilet, shower.
Access to black water tank.
Below cabin sole, fridge compressor, service batteries.
Large table and seating / berths to port and starboard, storage.
leading to forward forepeak with twin berths, storage, chain locker.
Hull plates 5.0 mm.
The skeg sides, keel sides 6.0 mm steel plate, keel bottom 12mm.
Deck and superstructure 5mm steel.
Shot blasted and primed with Jotun 87 primer and Hardtop AX.(2018)
25mm Spray foam insulation above water line (2019)
Galvanised steel shot ballast encapsulated in Epoxy resin in keel.
Wallas Spartan 50 Air Twin’ diesel heating.
Charge system by Solar panels (220W),
Leading Edge Wind Turbine on stern Arch. Victron controller.
Shore Power via Victron 240/110V Isolation transformer.
AGM 105A Engine, 300A Service, 260A Windlass batteries.
SeaGo Airfloor 2.4m tender (2022) +2.5HP Tohatsu O/B.
Fenders, warps.
Spay hood and cockpit enclosure.
Raymarine Network,
12 and 9" Axiom Pro plotters (CMap),
3 x i70 displays,
ACU400 Autopliot,
Quantum 18" Radar,
Wind,depth,speed, Lofrans winch control.
Standard Horizon GX2400E VHF & HX60 VHF.
Plastimo steering compass.
New Beta 60 diesel <50Hours.
Indirect cooling, 120A alternator,
Alternator to Battery charger,
PRM 150 gearbox.
Python drive, 40mm 316 shaft,
Deep sea seal.
4 blade 19"x13" fethering propellor with rope cutter.
Jefa pedastal cable steering.
Emergency direct rudder stock steering.
Engine/AC calorifier
Z-spars mast and spars,
Telescopic spinnaker pole,
316 standing rigging and bottle screws etc.(2022).
Crusader fully battened slab reef main with lazy jacks,
Furlex roller furl Genoa and stay sails.(2022).
Harken Self tailing deck winches 4 x sheet, 1 x reef, 2 x halyard.
1 x electric Lofrans windlass, remote and cockpit control,
60m 10mm chain,
Spade bower anchor .
6man SeaGo liferaft (in-test).
Automatic engine bay fire extinguisher,
3 manual extinguishers, fire blanket,
2 x auto bilge pumps, 1 x manual bilge pump
2 x Carbon Monoxide / smoke detectors
Gas detector
Deck light, 2-way speaker,
radar reflector,
Nav lights..
Note: Indicated location is approximate general area only.